Legal notice

Terms of Service & Legal Notice

By visiting our site and/or purchasing products from Torque Corner, you engage in our "Service" and agree to be bound by the following terms and conditions, including all additional policies referenced herein.

1. Governing Law

These Terms of Service and any separate agreements whereby we provide you Services shall be governed by, interpreted, and construed in accordance with the laws of the State of Queensland (QLD), Australia, and the Commonwealth of Australia, without regard to conflict of law principles.

2. Technical Specifications & Brand Clarification

We endeavor to present accurate product descriptions, torque ranges, calibration tolerances, and pricing. Independent Precision Tool Brand Notice: Torque Corner is an independent designer and retailer of calibrated torque wrenches, bicycle torque drivers, and automotive socket systems. Torque Corner is not affiliated with, sponsored by, or endorsed by Snap-on, Norbar, Stahlwille, CDI Torque, Park Tool, Tekton, or Sidchrome. Any comparative references are made strictly for standard square drive sizing (1/4", 3/8", 1/2"), ISO 6789 calibration standards, and consumer guidance. Torque Corner reserves the right to correct any inadvertent inaccuracies at any time without prior notice.

3. Never Use as a Breaker Bar, Zero-Setting Storage Rule & Fastener Safety Advisory

CRITICAL CALIBRATION PRESERVATION & BREAKER BAR PROHIBITION: A torque wrench is a precision measuring instrument—NEVER use a torque wrench to loosen rusted, seized, or over-tightened lug nuts or bolts, and NEVER attach a cheater pipe extension to the handle. Using a torque wrench as a breaker bar permanently shears internal calibration pawls and destroys accuracy. Always stop pulling smoothly the instant you hear or feel the primary tactile click; continuing to pull past the click over-torques and risks snapping bolts. Mandatory Zero-Setting Storage Rule: Immediately after finishing work, ALWAYS wind the micrometer handle back down to its lowest scale setting (or zero mark) before placing the wrench in its case—storing a click-type torque wrench under spring tension fatigues the internal spring and causes calibration drift. Never submerge torque wrenches in solvent tanks or parts washers, as this flushes out factory internal lubrication. Always wear certified safety eyewear (AS/NZS 1337.1) when working under vehicles or applying high torque. Torque Corner is not liable for loss of calibration caused by breaker-bar loosening or compressed spring storage, or fastener breakage resulting from pulling past the click.